DeWalt D25960 Guide D'utilisation page 8

Inserting and Removing 1-1/8" (28 mm)
Hex Accessories (Fig. 2, 3)
D25960
This machine uses chisels with a
1-1/8" (28 mm) hex shank.
Clean the chisel shank (Fig. 2).
TO FIT A CHISEL WITH GROOVE
IN THE SHANK (FIG. 3A)
1. Pull the tool retainer (D) to the
unlock position.
2. Hold the chisel in front of the tool holder with the groove (H)
facing upwards.
3. Insert the chisel shank into the tool holder (E). Ensure chisel
shank is correctly oriented as shown.
FIG. 3A
D
D25960
1-1/8"
(28 mm)
E
H
4. Push the retainer (D) backwards to lock the accessory in
5. Pull on the chisel to check if it is properly locked.The hammering
FIG. 2
6. To remove a chisel pull back the retainer (D) and pull the chisel
TO FIT A CHISEL WITH COLLAR ON THE SHANK (FIG. 3B)
1. Pull the tool retainer (D) to the unlock position.
2. Insert the chisel shank into the tool holder (E). Ensure chisel
3. Push the retainer (D) in line with the accessory shank to lock the
4. Pull on the chisel to check if it is properly locked.The hammering
D
5. To remove a chisel pull back the retainer (D) and pull the chisel
6
position.
function requires the chisel to be able to move axially several
centimeters when locked in the tool holder.
out of the tool holder (E).
shank is correctly oriented as shown.
accessory in position.
function requires the chisel to be able to move axially several
centimeters when locked in the tool holder.
out of the tool holder (E).
FIG. 3B
E
D
D