Philips WelcomeEye Comfort DES9500VDP - 531019 Notice D'utilisation page 37

• The Dual-family
mode is not working
• The additional
monitor is not
working
• The additional
intercom panel is not
working
• The electric strike
plate or lock does not
function
Notes:
To check whether or not the product is faulty, we recommend connecting it over a
short distance (3m of wiring). If the symptoms persist, the product is faulty. If not, check the
installation and cable used.
• Con guration
• Con guration
menu of the
monitors
• Connection
• Con guration
• Connection
• Con guration
• Con guration
menu of the
monitors
WelcomeEye Comfort / Compact / 09/17
• Verify that the intercom panel is not
programmed in dual-family mode.
Reminder: single-family =switch 2 set
to ON, dual-family =switch 2 set to
OFF. Don't forget to turn the power
o for ve seconds to activate the
new settings
• Verify that the monitors are valid
(BOTH of them)
• The monitors of family 1 must
be connected to 1 and 2 of the
intercom panel, those of family 2 to
3 and 4
• Verify that you have correctly
con gured the menus of your
monitors with 1 SINGLE master
terminal, the others MUST be
con gured as slaves
• Verify that the additional monitor
is connected to 1 and 2 of the
intercom panel for single-family
operation
• Verify the position of switch 1 on
the panels; it must be di erent.
Don't forget to turn the power o
for ve seconds to activate the new
settings
• Verify that the monitors are valid
(BOTH of them)
• The strike plate or electric lock
that you are ordering must have
a mechanical memory. The strike
plate current cannot exceed 1.1A.
• Connect it directly to terminals 7
and 8 at the back of the intercom
panel (no need to observe polarity).
• The opening function is only
possible if the video of the
respective intercom panel is
displayed.
GB15