Cleaning And Storage; Before First Use; Positioning The Product - SilverCrest SDK 2500 B1 Instructions D'utilisation Et Consignes De Sécurité

Cleaning and storage

m WARNING! Risk of
injury! Disconnect the product
from the power supply before
cleaning work and when not in
use .
Do not store the hot product
in a cupboard or in the
packaging .
Do not pull the power plug out
of the electrical outlet by the
power cord .
Protect the product, its power
cord and power plug against
dust, direct sunlight, dripping
and splashing water .
Store the product in a cool,
dry place, protected from
moisture and out of the reach of
children .
Protect the product against
heat . Do not place the product
close to open flames or heat
sources such as stoves or
heating appliances .
˜ Before first use
Remove the packaging . Check if all parts are
complete .
During production, some parts are covered
with a thin oil film for their protection .
Before first use, operate the product without
any pot/pan for about 3 minutes so that any
potential residues evaporate .
Clean the product (see "Cleaning and care") .
NOTE: The first few times the product is
heated up, a faint odour may be present .
Ensure sufficient ventilation in the area .
˜ Positioning the product
Place the product on a flat surface that leaves
enough space for ventilation .
A minimum of 10 cm of free space must
remain between the product and the adjacent
walls (including side and back wall) .
˜ Operation
NOTES:
Use pots/pans with flat, even bases for better
thermal transfer .
Use pots/pans matching the hob diameter .
Place the filled pot/pan on the desired
hob .
1 ] [ 3 ] [
Connect the power plug
socket-outlet .
to a suitable
9 ] [
GB/IE 21