Rear Panel Controls - Hartke HD 500 Mode D'emploi

Rear Panel Controls

1
2
3
4
1. Power Switch - Use this to power the amplifier on or off. When powered on, the
switch illuminates red.
2. AC Inlet - Attach the grounded AC power cord here to connect your amplifier
to mains power. This cord comes supplied with the appropriate plug for your
geographic area.
CAUTION: Do not use an adapter to defeat the third grounding pin on this plug
or severe electric shock may result!
3. Fuse Holder - The fuse holder comes from the factory with the appropriately
rated fuse for your model. If you need to change this fuse for any reason,
replace it with one that has the same exact rating.
4. Voltage Selection Switch - This switch is used to select the amplifiers operating
voltage
NOTE: Before using your speaker, be sure the voltage selection switch is set to
the correct voltage for your country. Be sure to install the properly rated fuse
when changing the operating voltage.
HD Series Combos
7