Cooking Area And Choice Of Pans; Control Panel - Dometic PI7078 Notice D'utilisation Et D'installation

EN IT
2. USE
2.2

Cooking area and choice of pans

The cooking areas are identified with permanent rings on the glass (A, B and C fig. 1 page 46). Electric heaters
are located under these rings on the glass. A dual electric heater is located in the area with 2 concentric
rings. In this area, either just the central part can be switched on (C fig. 1 page 46) or the entire plate (B+C
fig. 1 page 46).
Only use pans with perfectly flat and smooth bottoms. Do not use pans in cast iron or with rough bottoms
as they may scratch the surface of the cooking area.
Before cooking, make sure the bottom of the pan and the surface of the appliance are clean and dry.
The bottom of the pans must be more or less the same diameter as the cooking area to be used. This achieves
maximum heating efficiency without wasting energy.
Pans larger than the cooking area can be used provided their bottoms are always in the centre of the cooking
area. (fig. 2 page 47).
Do not use pans that exceed the external perimeter of the cooking area.
2.3

Control panel

To keep the control panel buttons in good condition:
• keep the glass clean (see para 2.5 "Cleaning");
• do not use gloves;
• use clean fingers;
• touch the glass lightly.
The control panel is described below:
16
Key lock button (with LED) (see ref. 1 fig. 1 page 46) for locking the buttons
(see para 2.4.1 "Key lock function").
ON/OFF button (see ref. 2 fig. 1 page 46) that switches the appliance on and off
(see para 2.4.2 "Turning the appliance on/of").
Symbols near the electric plate on/off and adjustment buttons (see ref. 3 fig. 1
page 46). The black ball shows the position of the electric plate on the hob.
Two buttons (for each electric plate) (see ref. 4 fig. 1 page 46) for switching and
adjusting the heating level of the plate (see para 2.4.3 "Selecting a heating level for
a certain plate").
Two buttons (see ref. 5 fig. 1 page 46) for adjusting the timer (see para 2.4.7
"Operating and setting the timer").
Symbol near the electric plate on/off and adjustment buttons (see ref. 6 fig. 1
page 46).
Dual plate button (with LED) (see ref. 7 fig. 1 page 46) for switching on/off the
external area of the dual plate (see ref. B fig. 1 page 46) (see para 2.4.5 "Switching
on the entire dual plate").