Parts Supplied; Connecting The Power Cord (1) - Pioneer AVIC-5201NEX Manuel D'installation

Parts supplied

This product Power cord
GPS antenna Microphone
Mini-jack extension USB cable
cable
Metal sheet Clamp (3 pcs.)
Double-sided tape

Connecting the power cord (1)

Yellow
To terminal supplied with power regardless of
ignition switch position.
Red
To electric terminal controlled by ignition
switch (12 V DC) ON/OFF.
Orange/white
To lighting switch terminal.
Black (ground)
To vehicle (metal) body.
With a two-speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.
White

Front speaker

White/black Gray/black
Left
Green

Rear speaker

Green/black Violet/black
This product
Fuse (10 A)
Gray

Front speaker

Right
Violet

Rear speaker

14 cm (5-1/2 in.)
Yellow/black (MUTE)
If you use equipment with a mute
function, connect that equipment to the
Audio Mute lead. If not, keep the Audio
Power supply
Mute lead free of any connections.
Power cord
NOTE
Audio source will be set to mute or attenuate, while the
following sounds will not be muted or attenuated. For
details, refer to Operation Manual.
– Voice guidance of the navigation
– Incoming ring tone and incoming voice of the
cellular phone that is connected to this product
via Bluetooth wireless technology
Blue/white (SYSTEM REMOTE CONTROL)
To auto-antenna relay control terminal or antenna
booster power control terminal (max. 300 mA 12 V
DC). If the vehicle has a glass antenna, connect to the
antenna booster power control terminal (max. 300
mA 12 V DC).
5
En