Adjusting The Microphone Angle; After Installation; After Installing This Product - Pioneer AVIC-5201NEX Manuel D'installation

Masquer les pouces Voir aussi pour AVIC-5201NEX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Microphone
A
Tab
B
Microphone base
C
Microphone clip
D
2
Mount the microphone on the
steering column.
Install the microphone on the
steering column, keeping it away
from the steering wheel.
1
2
Double-sided tape
A
Clamps
B
Use separately sold clamps to secure the
lead where necessary inside the vehicle.

Adjusting the microphone angle

The microphone angle can be adjusted.

After installation

After installing this
product
1
Reconnect the negative (–) terminal
of the vehicle's battery.
First, double-check that all connections
are correct and that this product
is installed correctly. Reassemble
all vehicle components that you
previously removed. Then reconnect
the negative (–) cable to the negative
(–) terminal of the battery.
2
Start the engine.
3
Press the RESET button.
Press the RESET button on this
product with a pointed object such
as the tip of a pen.
Some of the settings and recorded
contents will not be reset.
4
Change the settings as desired.
For details concerning operations,
refer to Operation Manual.
5
Drive down an unobstructed road
until the GPS starts receiving the
signal normally.
NOTE
After installing this product, be sure to check
at a safe place that the vehicle is performing
normally.
En
15

Publicité

Chapitres

Table des Matières
loading

Table des Matières