Installation; General - Hatco HWB Série Manuel D'installation

General

Built-In Heated Well units are shipped from the factory with
most components assembled and ready for use. Use the
following procedures to install the unit.
WARNING
ELECTRIC SHOCK HAzARD:
• Unit must be installed by qualified, trained installers.
Installation must conform to all local electrical and
plumbing codes. Installation by unqualified personnel
will void the unit warranty and may lead to electric
shock or burn, as well as damage to unit and/or its
surroundings. Check with local plumbing and electrical
inspectors for proper procedures and codes.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 21°C (70°F).
FIRE HAzARD:
• Install unit with a minimum of 89 mm (3-1/2") of space
from bottom of unit to all combustible surfaces to
prevent combustion.
• Unit must be installed using ribbon putty gasket
between the unit and the installation surface per
installation instructions.
CAUTION
Locate the unit at the proper counter height in an area that
is convenient for use. The location should be strong
enough to support the weight of the unit and contents.
NOTICE
Units are voltage-specific. Refer to specification label for
electrical requirements before beginning installation.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to the unit.
Remote mounted control panels must have a minimum 6"
(152 mm) clearance from unit (not to exceed 72"
[1829 mm]). Mounting control panel closer may cause heat
damage to electrical system in control panel.
UL recognized units must be installed according to UL
guidelines. Complete UL approval of this component is the
responsibility of the installer/fabricator and not the Hatco
Corporation.
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under the
Hatco warranty. Contact the manufacturer of the
countertop material for application information.
Form No. HWBCEM1-0515
NOTE: All Built-In Heated Wells require the control box be
remote mounted in the vertical position.
1. Remove the unit from the shipping carton and remove all
packing materials.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTaNT OWNER INFORMaTION section for
details.
2. Remove tape and protective packaging from all surfaces
of the unit.
NOTE: A qualified electrician is recommended for connecting
the Built-In Heated Well units to a power source. A
qualified plumber is recommended for connecting
drain.
3. Install the unit in the desired location. Use the appropriate
procedure in this section for combustible or non-
combustible countertops.
IMPORTANT NOTE:
For bottom mount units, see "Installing a Bottom Mount Unit"
in this section before performing any countertop cutouts.
4. Install the remote mounted control box (refer to the
procedure in this section).
13

INSTALLATION