Adjusting The Display Contrast; Aux Function - Clarion CMD4 Mode D'emploi

Operations Common to Each Mode
Adjusting the non-fader
∗ The factory default setting is "NFVOL 0".
(Adjustment range: –6 to +6)
1. Press and hold the [MENU] button for 1
second or longer to switch to the menu
mode.
2. Press the [a] or [d] button to select "NF
VOL".
3. Turn the [ROTARY] knob to adjust the non-
fader volume.
4. Press the [MENU] button to return to the
previous mode.

Adjusting the display contrast

You can adjust the display contrast to match the
angle of installation of the unit.
∗ The factory default setting is "8". (Adjustment
level: 1 to 8)
1. Press and hold the [MENU] button for 1
second or longer to switch to the menu
mode.
2. Press the [a] or [d] button to select
"CONTRAST".
3. Turn the [ROTARY] knob to adjust the
contrast.
4. Press the [MENU] button to return to the
previous mode.
Selecting AUX IN sensitivity
Make the following settings to select the
sensitivity when sounds from external devices
connected to this unit are difficult to hear even
after adjusting the volume.
∗ The factory default setting is "MID".
1. Press and hold the [MENU] button for 1
second or longer to switch to the menu
mode.
2. Press the [a] or [d] button to select "AUX
SENS".
3. Turn the [ROTARY] knob to select from
"HIGH", "MID" or "LOW".
4. Press the [MENU] button to return to the
previous mode.
16
CMD4
Performing a system check
This function verifies the devices hooked up
through CeNET.
1. Press and hold the [MENU] button for 1
second or longer to switch to the menu
mode.
2. Press the [a] or [d] button to select "S-
CHECK".
3. Press and hold the [ENT] button for 1 second
or longer to start the system check.
CeNET connection configuration is
automatically checked.
When the system check is complete, the
display returns to the previous mode.

AUX function

This system has an external input jack so you
can listen to sounds and music from external
devices connected to this unit.