Cleaning; Paint; Baffle Plates - Dik Geurts Aste 5 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USER M ANUA L

6.1 Cleaning

You can clean your fire whenever you want.
Ø
Clean the outside of the fire with a soft duster.
do not use corrosive or abrasive cleaning agents when cleaning your fire and/or glass pane, in order to prevent
!Caution
damage;
do not use water when cleaning, as the heat-resistant paint is not water repellent. Water may cause rust spots;
do not put glasses, cups, etc. on the fire. Rings may cause rust spots.
Ø
Remove any deposits on the glass pane using the supplied glass pane cleaning agent. For this, observe the user
manual on the packaging (see section 6.6).
The glass pane cleaning agent is available via your supplier/installer.
!Tip

6.2 Paint

Damages to the paint, resulting from objects that have fallen/been placed against the casing of the fire, are not
!Caution
covered by the warranty.
Paint is not anti-corrosive; be careful with moisture in and around the fire. The formation of rust or discolouration is
!Caution
not covered by the warranty.
Small damages to the paint you can repair yourself, using the supplied spray can. It will be available via your
supplier/installer.
If, nevertheless, a rust spot appears on your fire, you can remedy this as follows:
Ø
Carefully sand the rust spot with steel wool.
Ø
Then treat this area with the supplied paint. Prior to this, you should check whether the colour indicated on the
spray can corresponds with the fire. In case of doubts, please contact your dealer.
Ø
Make sure the direct vicinity of the fire is covered, because of possible excess spraying.
In case of damage to the paint, retouch an entire area and not only the damaged spot. This prevents
!Tip
discolourations and spots.

6.3 Baffle plates

At the top of the fireplace you will find the so-called flame baffle plates (see Appendix 2, Fig. 9). These plates
increase the temperature in the fire and therefore the efficiency.
The flame baffle plates are easily replaced. In case of some fires, the bottom and side wall lining must be removed
first. For assembly and disassembly, please see the appliance specific section in the installation manual.
in case of collisions, the plate might break. When chimney sweeping, check the baffle plates for crack(s);
!CAUTION
when chimney sweeping, remove the baffle plates. Mark them so they can be returned at the same location.
when placing them back, check whether the baffle plates still fit properly in their intended profiles;
in case of excess condensation in the chimney, the flame baffle plate can become saturated with moisture and
therefore easily break. Consult your dealer/installer for a solution, if this problem occurs.
Ø
Do not burn the fire with no flame baffle plate.
Ø
If necessary, replace a broken or poorly fitting plate. It can be ordered via your supplier. Keep the old plate for the
dimensions.
The risk of a chimney fire is greater if you burn your fire without a flame baffle plate.
!CAUTION
2 6
UK

Publicité

Table des Matières
loading

Table des Matières