8: Preparing The Receiver And The Remote Control; Connecting The Ac Power Cord (Mains Lead) - Sony STR-DA2800ES Mode D'emploi

• If the receiver is used in an environment in
which there is power supply noise from
electric products or in a noisy network
environment, use a shielded-type LAN
cable.
8: Preparing the receiver
and the remote control
Connecting the AC power cord
(mains lead)
Connect the supplied AC power cord (mains
lead) to the AC IN terminal on the receiver
firmly, then connect the AC power cord (mains
lead) to a wall outlet.
A several space is left between the plug and the
rear panel even when the power cord (mains
lead) is inserted firmly. The cord is supposed
be connected this way. This is not malfunction.
AC IN terminal
To the wall outlet
AC power cord
(mains lead)
(supplied)
Turning on the receiver
?/1
Press ?/1 to turn on the receiver.
You can also turn on the receiver using ?/1 on
the remote control.
When you turn off the receiver, press ?/1
again. "STANDBY" flashes on the display
window. Do not disconnect the AC power cord
(mains lead) while "STANDBY" is flashing.
This may cause a malfunction.
To save the power in standby
mode
Set "Control for HDMI" (page 104), "Pass
Through" (page 104), "Network Standby"
(page 106), and "RS232C Control" (page 111)
to "Off" or "Auto" (for "Pass Through" only),
and turn off the power for zone 2.
If "Control for HDMI" (page 104), "Pass
Through" (page 104), or "Network Standby"
(page 106) is set to "On," or the power for
zone 2 is turned on, the lamp above ?/1 lights
up in amber.
Note
The top of the receiver may become hot while the
receiver is in standby mode. This condition occurs
because current is flowing in the internal circuits of
the receiver. This is not a malfunction.
43 US