Mounting; Standard Installation - Helios MiniVent M1/100 N/C Notice De Montage Et D'utilisation

Installation and Operation Instructions
UK
WARNING
MiniVent M1/100/120 N / C
– Check freewheeling of the impeller
– Check all parts for tightness, particularly screws, protection guards. Do not loosen screws in the process!
– Check fan for vibration and noise during test run
– Compare power consumption to rating plate data
fig.12
˜
Sealing
compound
7 mm
100 mm
- Length of single conductors 100 mm
- Stripping length 7 mm
- Strip sheathed cable flush with cable duct
6.5

Mounting

fig.14
Duct channel
90° bend
Assembly in cramped
fig.13
1. Align terminal compartment cover
attach and screw to casing.
2. Then snap-in facia
fig.15
Mount guide
Fan
vane with
back draught
shutter at the
end of the
duct or just
omit it.
conditions
Room side
10
–
—
Attach terminal
compartment cover
with groove,
—
– .
WES 1.. or
TWH 1..
Core drill
hole
M1/100 N / C
= Ø 115 mm
M1/120 N / C
Guide vane with
= Ø 130 mm
back draught
shutter

Standard installation

Outside