dirna Bergstrom bycool COMPACT 1.4 Instructions De Montage page 21

COMPACT
Position the interior air distribution panel on the
11
front studs with (1) M6 wide-rimmed washer
and (1) M6 nut on each stud. Tighten the nuts
until the foam duct comes up against the unit's
upper foam.
IMPORTANT: The rubber ducting must
being run into the upper rubber of the unit
to avoid air leaks.
11
EPDM
Gasket
Cabin roof
Upholstey
Tighten the nut in point 10a until it comes
12
up against the top part of the interior air
distribution panel.
12
EPDM
Gasket
Cabin roof
Upholstey
Unit base
D
Nut M6
Unit base
Nut M6 (10a)
Nut M6
Air conditioning for vehicles
Rubber ductings
Rubber ductings
21
EN
Foam
Interior air distribution
panel
Foam
Interior air distribution
panel