Elba cook MASTERline 136 PX 634 Mode D'emploi page 49

IMPORTANT:
The gasket "D" (fig. 9.3) is the element
that guarantees the seal in the gas con-
nection. It is recommended that it be
replaced whenever it shows even the
slightest deformation or imperfection.
In particular, make sure that:
– the flexible hose does not come into
contact with any parts of the cooker
with surface temperatures in excess of
70°K;
– flexible hose does not come into
contact with sharp edges or corners;
– the hose is not under tension or
twisted and is not kinked or too tightly
bent;
– the connection with rigid metal pipes
should not cause stresses to the gas
ramp.
– we advise replacing the gasket on the
slightest sign of deformation or imper-
fection.
– the hose can easily be inspected
along its entire length to check its
condition; hoses should replaced after
a maximum of three years.
– the cylinder cock or the supply cock
immediately ahead of the appliance is
closed whenever the cooker is not in
use.
IMPORTANT: (only for England)
Before connecting to the gas remove
the reduction "B" or "C" on the appli-
ance and mount the conical union
"E" supplied.
The fitting (fig. 9.3) is made up of:
A - Gas train terminal fitting
B - Hose connector for G30/G31 gas
C - Hose connector for G20 gas
D - Gasket
E - Conical union
Fig. 9.2
IMPORTANT:
To replace hose connector or to screw
the connecting tube it is necessary to
operate with 2 spanners (fig. 9.2).
After connecting to the mains, check
that the couplings are correctly
sealed, using soapy solution, but
never a naked flame.
A
D
B
C
Fig. 9.3
E
49