Canon CS100 Mode D'emploi page 20

4-A
[WPS Push button connection (PBC)]
First, check whether the access point you will use supports WPS (Wi-Fi Protected
Setup).
18
Select an item.
3
Select an item, then press <S>.

Select a step as appropriate for

the item.
• [Find network]:
Go to step 4-B (p.19).
• [WPS Push button
connection (PBC)]:
Go to step 4-A.
• [Skip Wi-Fi settings]:
Go to step 5.
When Connect Station is

connected via a wired LAN (p.16),
this screen will not be displayed.
Go to step 5.
Press the access point's WPS

button while the screen shown on
the left is displayed.
For details about where the

button is located and how long to
press it, refer to the access
point's instruction manual.

When the connection is complete,
the [Set date/time] screen will
appear.
Set the date and time.
5
Press the <h> <g> keys to select

the item you want to change and
press the <d> <f> keys to
change the value.
When you finish the setup, press

<S>.
Check the settings.
6
When the setting complete

screen appears, the initial setting
is complete. Check the settings,
then press <S>.
 The Home screen will appear
(p.20).