Replacing The Blade - RIDGID R48607 Manuel D'utilisation

OPERATION

REPLACING THE BLADE

See Figure 24.
WARNING:
A 7-1/4 in. blade is the maximum blade capacity of
the saw. Never use a blade that is too thick to allow
outer blade washer to engage with the flats on the
spindle. Larger blades will come in contact with the
blade guards, while thicker blades will prevent the
blade bolt from securing the blade on the spindle.
Either of these situations could result in a serious
accident and can cause serious personal injury.
 Remove the battery pack from the tool.
 Raise saw arm.
 Rotate lower blade guard up and loosen blade bolt cover
screw. Slide blade bolt cover toward upper blade guard
to expose the blade bolt.
 Depress the spindle lock button and rotate the blade bolt
until the spindle locks.
 Using the wrench provided, loosen and remove the blade
bolt.
NOTE: The blade bolt has left hand threads. Turn blade
bolt clockwise to loosen.
 Remove the outer blade washer. Remove the blade.
 Wipe a drop of oil onto the inner blade washer and the
outer blade washer where they contact the blade.
WARNING:
If inner blade washer has been removed, replace
it before placing blade on spindle. Failure to do
so could cause an accident since blade will not
tighten properly.
 Fit saw blade inside upper blade guard and onto spindle.
The blade teeth point downward at the front of saw as
shown in figure 24.
 Replace the outer blade washer. The double "D" flats on
the blade washers align with the flats on the spindle.
 Depress spindle lock button and replace blade bolt.
NOTE: The blade bolt has left hand threads. Turn blade
bolt counterclockwise to tighten.
CAUTION:
Always install the blade with the blade teeth and
the arrow printed on the side of the blade pointing
down at the front of the saw. The direction of blade
rotation is also stamped with an arrow on the upper
blade guard.
NOTE: BEFORE USE, REPLACE SCREW AND
TIGHTEN SECURELY TO PREVENT GUARD
MOVEMENT
COVER SCREW
NOTE: BEFORE USE, REPLACE
SCREW AND TIGHTEN
SECURELY TO PREVENT
GUARD MOVEMENT
BLADE
TO
LOOSEN
BLADE
BOLT
TO
TIGHTEN
BLADE
WRENCH
 Tighten blade bolt securely.
 Replace blade bolt cover and tighten blade bolt cover-
screw securely.
 Lower the blade guard.
 Raise and lower the saw arm to ensure lower blade guard
functions correctly.
19 - English
OUTER
BLADE BOLT
BLADE
WASHER
BLADE
BOLT
BLADE BOLT
COVER SCREW
BLADE BOLT
COVER
OUTER BLADE
WASHER WITH
DOUBLE "D" FLATS
BLADE
INNER
BLADE
WASHER
LOWER
BLADE
GUARD
Fig. 24