Installing The Work Clamp - RIDGID R48607 Manuel D'utilisation

ASSEMBLY
INSTALLING SLIDING MITER FENCE
See Figure 11.
 Turn the fence lock knob counterclockwise, to clear fence
slots.
 Install the sliding miter fence. Lower fence into fence
slot. Be sure side of fence lines up flush with side of fixed
fence.
 Tighten fence lock knob securely.

INSTALLING THE WORK CLAMP

See Figure 12.
WARNING:
In some operations, the work clamp assembly may
interfere with the operation of the blade guard as-
sembly. Always make sure there is no interference
with the blade guard prior to beginning any cutting
operation to reduce the risk of serious personal injury.
The work clamp provides greater control by clamping the
workpiece to the table. It also prevents the workpiece from
creeping toward the saw blade. This is very helpful when
cutting compound miters.
Depending on the cutting operation and the size of the
workpiece, it may be necessary to use a C-clamp instead of the
work clamp to secure the workpiece prior to making the cut.
To install the work clamp:
 Place the shaft of the work clamp in either hole on the
miter table base.
 Rotate the knob on the work clamp to move it in or out
as needed.
SLIDING MITER
FENCE
SLOT
FENCE LOCK
KNOB
WORK
CLAMP
BASE
INDICATOR
SCREW
Fig. 11
SCALE
INDICATOR
14 - English
BEVEL STOP PIN
INDICATOR
SCREW
MITER
MITER SCALE
LOCK LEVER
DETENT PLATE
BEVEL
SCALE
Fig. 12
SCALE
INDICATOR
DETENT
RELEASE
BUTTON
Fig. 13
Fig. 14