Cata ME 406 TC Instructions page 38

Fig. 7: Ventilation and gap requirements for the installation of e
simple electric oven in a standard cooking unit.
Minimum ventilation requirements for upper, base and support
shelves for the rear part of the unit.
A. Rear panel
B. Storage space
C. Remove the rear part of this section
D. Real panel
E. Storage space
F. Base
G. Minimum ventilation gap 80 cm2
Fig. 8: Ventilation and gap requirements for the installation of a
simple electric oven in an upper cupboard.
ELECTRICAL CONNECTION
Before connecting the appliance, check that the voltage mar-
ked on the specifications plate coincides with the voltage of
the electricity network.
The NICEIC register is recommended for electrical installa-
tions.
WARNING – THIS APPLIANCE MUST BE EARTHED
This appliance must be wired to a 13 A bipolar automatic
switch with protected socket, which has a 3 mm separation
between contacts and is placed in an easily accessible place
next to the appliance.
IMPORTANT
The conductors of the network power supply lead are coded
by colours are follows:
Green and yellow -Earth
Blue - Neutral
Brown - Live
• The green and yellow conductor must be connected to the
terminal marked "E" or with the symbol of the earth or which
is green and yellow.
• The blue conductor must be connected to the terminal marked "N".
• The brown conductor must be connected to the terminal marked "L".
• The lead must not reach a temperature higher than 50 ºC abo-
ve the ambient temperature at any point.
• If the power lead is damaged, it must be replaced by a special
lead or unit supplied by the manufacturer or it after-sales service.
REPLACEMENT OF THE NETWORK POWER SUPPLY LEAD
If it is necessary to replace the network power supply lead,
proceed as follows:
1. Disconnect the appliance from the power supply, unscrews
the fastening screws and remove the rear panel.
2. Unscrew the fastening screws and those of the terminals to
free the existing lead.
3. Assemble the replacement lead which must comply with the
information listed in the Specifications, ensuring the correct
connection of the colour codes and that all the screws are co-
rrectly tightened.
MAINTENANCE
Before carrying out maintenance, disconnect the appliance
from the power supply.
During the guarantee period, if necessary all services should
be commissioned to the Manufacturer's Technical Assistance
Service Department. Bear in mind that intervention or repair
by unauthorised personnel will invalidate this guarantee.
REPLACEMENT OF THE OVEN LIGHTBULB
(Not covered by the appliance guarantee.)
The oven has a light with the following characteristics: 15 W or
25 W, 300 ºC and type E-14
WARNING: Disconnect the appliance from the electricity
supply, remove the oven door (as described above), as well as
the oven shelves.
Remove the glass cover that protects the light bulb by turning it
anti-clockwise. Fig. 9 (A)
Unscrew the old light bulb and dispose of it safely and ecologically, change
it for one as specified in the Specifications and replace the cover.