Failure Display And Inspection - AYA ATI4B Instructions D'utilisation

The induction hob
or a cooking zone
has turned itself off
unexpectedly, a
tone sounds and an
error code is
displayed
(typically alternating
with one or two
digits in the cooking
timer display).

Failure Display and Inspection

If an abnormality comes up, the induction hob will enter the protective state automatically
and display corresponding protective codes:
Problem Possible causes
F3-F8 Temperature sensor failure
F9-FE
Temperature sensor of the IGBT
failure.
E1/E2 Abnormal supply voltage
E3/E4 Abnormal temperature
E5/E6 Bad induction hob heat
radiation
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the
induction hob.
Technical fault. Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
What to do
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
Please inspect the pot.
Please restart after the
induction hob cools down.
57