Installation And Assembly; Notes; Space Requirements - Reflex exvoid A 60.3 Mode D'emploi

3.4

Installation and assembly

3.5

Notes

The following items must be considered when assembling and installing the equipment:
• The flow direction is not pre-determined.
• Ensure a vertical and stress-free installation.
– Any stresses that may occur in some cases must be countered by appropriate constructive actions. Stresses may be caused by
temperature effects, for example.
• Ensure sufficient bearing capability of the installation site.
– This applies to filling the separator with water in particular.
• The equipment is not a load-bearing construction element.
– By default, the calculation of the vessels does not take lateral acceleration forces into account. Avoid alternating stresses such
as pressure shocks, abrupt pressure changes, or strong vibrations.
• Use only approved transport and lifting gear.
– The eyes provided on the device are intended solely as
installation aids.
• The angle (1) of the lifting tackles must be maximum 60°.
3.6

Space requirements

A: Minimum free space above the top part of the ventilation
Type: Type:
82511 xx 82531 xx
82513 xx 82532 xx
82533 xx
82534 xx
50 mm 50 mm
B: Minimum free space below the draw-off tap
Connection Connection
DN 50 / 65 OD 60.3 / 76.1
DN 80 / 100 OD 88.9 / 114.3
DN 125 / 150 OD 139.7 / 168.3
DN 200 OD 219.1
DN 250 OD 273.0
DN 300 OD 323.9
Type: Type:
82531 xx 82521 xx
82532 xx 82522 xx
82533 xx 82523 xx
82534 xx 82524 xx
400 mm 300 mm
550 mm 400 mm
750 mm 500 mm
1000 mm 700 mm
1350 mm 850 mm
1700 mm 1000 mm
Reflex ex separator — 27.01.2014
1
A
B
Technical data
60°
A
B
English — 9