Installation And Assembly; Notes; Space Requirements - Reflex Exvoid A 60.3 Mode D'emploi

4

Installation and assembly

CAUTION
Risk of burns
Escaping hot medium can cause burns.
• Maintain a sufficient distance from the escaping medium.
• Wear suitable personal protective equipment (safety gloves and goggles).
4.1

Notes

The following items must be considered when assembling and installing the equipment:
• Do not install the device above sensitive components or close to electrical plant.
• Perform installation in dry and frost-proof locations.
• The flow direction is not pre-determined.
• Ensure a vertical and stress-free installation.
– Any stresses that may occur in some cases must be countered by appropriate constructive actions. Stresses may be caused by
temperature effects, for example.
• Ensure the device is readily accessible in its place of installation.
• Ensure sufficient bearing capability of the installation site.
– This applies to filling the separator with water in particular.
– If necessary additional structural measures may be required to ensure adequate load
bearing capacity.
• The device is not a load-bearing structural element.
– By default, the calculation of the vessels does not take lateral acceleration forces into
account. Avoid alternating stresses such as pressure shocks, abrupt pressure changes, or
strong vibrations.
• Use only approved transport and lifting equipment.
– The eyes provided on the device are intended solely as installation aids.
• The angle (1) of the lifting tackles must be maximum 60°.
• After attachment of insulation, attach the additional sticker on the outside so that it is readily
visible.
• Thoroughly rinse the system through after installation of the Reflex Exdirt.
4.2

Space requirements

A: Minimum free space above the top part of the ventilation
Type:
82511xx / 82513xx / 82531xx / 82532xx / 82533xx / 82534xx
50 mm
Note!
For connection size DN 450 or greater we recommend
increasing the minimum space requirement to provide access
for servicing of the vent.
B: Minimum free space below the draw-off tap
• For installation of an Exferro magnetic insert
• For removal of a grid pipe for separators with service flange
Note!
• You can find a detailed listing of all data at the end of the complete document.
• Welded connection only up to DN 300
Reflex ex separator — 21.11.2016
Installation and assembly
English — 21