Télécharger Imprimer la page

Montage; Mounting; Montaggio; Montaje - HEIDENHAIN TTR ECA 4400 Instructions De Montage

Publicité

Mounting

Montage

Montage

Montaggio

Montaje

Follow the Mounting Instructions carefully!
– The mounting surfaces and threads must be clean and free of burrs and paint. The specified shaft tolerances must be complied with.
– Screw connections must comply with friction class B according to VDI 2230.
– The scale drum is to be fastened with all provided screws and washers.
– Do not use the back-off thread for fastening.
– The screws must be tightened to the specified tightening torque according to the Mounting Instructions and secured against unintentional loosening.
– The speed values specified for the scale drum apply only when the warnings are observed.
Montagehinweise dringend beachten!
– Montageflächen und Gewinde müssen grat-, lackfrei und sauber sein. Angegebene Wellentoleranzen müssen eingehalten werden.
– Schraubverbindungen müssen der Reibungszahlklasse B nach VDI 2230 entsprechen.
– Die Teilungstrommel ist mit allen vorgesehenen Schrauben und Scheiben zu befestigen.
– Abdrückgewinde nicht zur Befestigung verwenden.
– Die Schrauben sind entsprechend der Montageanleitung mit dem angegebenen Anzugsdrehmoment festzuschrauben und gegen unbeabsichtigtes Lösen
zu sichern.
– Die für die Teilungstrommel spezifizierten Drehzahlwerte gelten nur bei Beachtung der genannten Warnhinweise.
Respecter impérativement les instructions de montage !
– Les surfaces de montage et les filetages doivent être propres, sans bavures ni peinture. Les tolérances indiquées pour l'arbre doivent être respectées.
– Les connexions à visser doivent correspondre à la classe des coefficients de frottement B, selon la norme VDI 2230.
– Le tambour gradué doit être fixé avec l'ensemble des vis et rondelles prévues.
– Ne pas utiliser le filetage d'éjection pour la fixation.
– Les vis doivent être fixées en respectant le couple de serrage spécifié dans les instructions de montage et elles doivent être sécurisées contre le risque de
détachement involontaire.
– Les valeurs de vitesse de rotation pour le tambour gradué ne s'appliquent qu'en tenant compte des messages d'avertissement mentionnés.
8

Publicité

loading