Setup Selector - codanova VMX v.64 Manuel D'utilisation

Setup selector

The selector below your VMX v64 will let you modify the behavior or the messages sent by it.
In order to avoid any unwanted change in the configuration selector, the position of the selector
is read only at startup.
If you want to change the selector:
- Power off the VMX v64 and shut down your software
- Modify the positions of selector switches
- Power on the VMX v64. This will load the new setup
- When VMX v64 is recognized by the operating system (after 5 seconds), restart the
software.
On the drawing above, all position indicators are low, in the OFF position.
On the drawing above, all position indicators are on top, in the ON position.
Page 24/38