DeWalt DCS334 Guide D'utilisation page 12

English
To remove no-mar shoe cover, grasp the no-mar shoe
cover from the bottom; holding onto the two rear tabs
remove the no-mar shoe cover.
Fig. I
16
Anti-Splinter Insert (Fig. A, I, J)
nOTE: Do not use the anti-splinter insert with the flush
cutting blade.
The anti-splinter insert 19 should be used when trying to
minimize tear-out, especially when cutting veneer, laminate,
or finished surfaces, such as paint. The anti-splinter insert
should be installed into the no-mar shoe cover
no-mar cover is not used, install anti-splinter insert into
shoe 7 .
Fig. J
Setting the Electronic Sawing Speed
(Fig. A, K)
DCS334
To preset the sawing speed, turn the speed control dial
to the desired level. The higher the number on the speed
control dial, the higher the sawing speed. The sawing speed
varies with the pressure exerted on the variable speed
trigger , but will not exceed the speed that is set by the
1
speed control dial 3 . The required setting depends on the
thickness and kind of material.
nOTE: Use high speeds for sawing soft materials such
as wood.
10
DCS335
17
The speed control dial
the required range of speed.
1. Turn the electronic control dial to the required level.
17
The DCS335 will turn on at that speed when the on/off
switch is moved to the ON position. The required setting
depends on the thickness and kind of material.
nOTE: Use high speeds for sawing soft materials such
as wood.
Fig. K
7
Worklights
The worklights are located on either side of the blade.
To turn on the worklight, depress the trigger (DCS334)
16 . If the
or switch on the on/off switch (DCS335). Worklights will
remain on 20 seconds after the trigger is released or the on/
off switch is moved to the off position.
nOTE: The worklights are for lighting the immediate work
19
surface and are not intended to be used as a flashlight.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. A, L)
DCs335: Move the on/off switch
before inserting the battery pack.
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
3
To remove the battery pack from the tool, press the release
button 11
handle. Insert it into the charger as described in the charger
section of this manual.
3 can be used for advance setting of
to the OFF position
1
10 into the tool handle, align the
and firmly pull the battery pack out of the tool
3