Maintenance - Ryobi OP140 Manuel D'utilisation

CHARGING A COOL BATTERY PACK
If the battery pack is below normal temperature range, the
red LED will begin flashing. When the battery warms to a
temperature of more than 32°F, the charger will automatically
begin fast charge mode.
CHARGING RYOBI LITHIUM-ION BATTERY
PACKS
Lithium-ion batteries deliver fade free power for their entire
run time. 24 V lithium-ion tools will not gradually lose power
due to decreasing battery charge. Instead, power from the
battery pack will drop from full to zero once the full charge
has been drained from the battery. Once this happens,
recharging of the battery is required.
It is not necessary to drain the battery pack completely
before recharging.
WARNING:
When servicing use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 during product operation. If
operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any

maintenance.

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
COLD WEATHER OPERATION
The lithium-ion battery pack can be used in temperatures
down to -4°F. Put the battery pack on a tool and use the tool
in a light duty application. After about a minute, the pack will
warm up and begin operating normally.
LED FUNCTION OF CHARGER
See Figure 3, page 9.
CHARGER LED WILL FUNCTION AS FOLLOWS
TO INDICATE STATUS OF CHARGER AND
BATTERY PACK:
 Red LED on, Green LED off = Power to charger is on.
 Red LED flashing, Green LED off = Battery is being tested.
 Red LED fading, Green LED off = Battery is defective.
 Red LED on, Green LED flashing = Battery is charging.
 Red LED off, Green LED on = Battery is fully charged.
 Red LED off, Green LED fading on and off = Battery is
fully charged; charger is in Energy Save mode. Charger
will periodically wake from Energy Save mode to ensure
the battery pack remains in a fully charged state.
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
STORAGE
Always remove the battery pack before storing the charger
or any time the charger is unplugged.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
7 — English
WARNING: