Care And Cleaning - Zanussi ZDF4010 Notice D'utilisation

Cancelling a washing programme
1. Press and hold function buttons B and C until:
– All the programme lights come on,
– The programme-in-progress indicator light goes
off.
2. Release function buttons B and C to cancel the wash-
ing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent before you
set a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of interrup-
tion.
Setting and starting a washing programme with
delay start
1. Press the on/off button.
2. Set a washing programme.
3. Press the delay start button until the display shows
on flashing the necessary delay start of the washing
programme.
4. Close the door.
– The number on the display comes on with fixed
light.
– The programme-in-progress indicator light goes
off.
– The countdown of the delay start starts.
– The countdown of the delay start decreases with
steps of 1 hour.
– When the countdown is completed, the washing
programme starts automatically.
– The programme-in-progress indicator light
comes on.

Care and cleaning

Warning! Switch the appliance off before you
clean the filters.
12
Do not open the door during the countdown to pre-
vent interruption of the countdown. When you
close the door again, the countdown continues from the
point of interruption.
Cancelling a delay start:
1. Press and hold function buttons B and C until:
– All the programme lights come on.
When you cancel a delay start, you also cancel the
washing programme.
2. Set a new washing programme.
End of the washing programme
• The appliance stops automatically.
• The display shows 0.
• The end-of-programme indicator light comes on.
• The programme-in-progress indicator light goes off.
1. Switch off the appliance.
2. Open the door.
3. For better drying results, keep the door ajar for
some minutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Removing the load
• First remove items from the lower basket, then from
the upper basket.
• There can be water on the sides and door of the appli-
ance. Stainless steel becomes cool more quickly
than the dishes.
Standby mode
If you do not switch off the appliance at the end of the
washing programme, the appliance automatically goes
into standby mode. The standby mode decreases ener-
gy consumption.
Three minutes after the end of the programme, all indi-
cator lights go off and the digital display shows one hor-
izontal bar.
Press one of the buttons (not the on/off button), to go
back to end-of-programme mode.
Cleaning the filters
Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.