Transportation, Storage And Disposal; Technical Data - Husqvarna LB 248S Manuel D'utilisation

• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, see
page 14 .(Fig. 38 )
• Replace the spark plug if it is necessary.
To examine the fuel system
• Examine the fuel tank cap and the seal for the fuel
tank cap to make sure that there are no damages.
• Examine the fuel hose to make sure that there are
no leaks. If the fuel hose is damaged, let a service
agent replace it.
To adjust the clutch wire
If the drive starts to feel slow, it is necessary to adjust
the clutch wire.
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
• Safely attach the product during transportation to
prevent damage and accidents.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.

Technical data

Engine
Brand
3
Displacement, cm
Speed, rpm
Nominal engine output, kW
Ignition system
Spark plug
1
The power rating of the engine indicated is the average net output (at specified rpm) of a typical production
engine for the engine model measured to SAE standard J1349/ISO1585. Mass production engines may differ
from this value. Actual power output for the engine installed on the final product will depend on the operating
speed, environmental conditions and other values.
14
Technical data on

Transportation, storage and disposal

Technical data
LB 248S
Briggs & Stratton
163
2900
1
2.4
BS OHV 992304
1. To increase the drive speed, turn the adjuster screw
counterclockwise.
Note: If the drive is engaged when you do not pull
the drive bail, it is necessary to extend the wire.
2. To extend the wire and decrease the drive speed,
turn the adjustment screw clockwise.(Fig. 39 )
If the drive feels slow also after the adjustment, let an
approved service agent replace the drive belt.
• Keep the product in a dry and frost free area.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or
antifreeze, at a service center or at an applicable
disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
• Discard the battery at a service center or discard it at
a disposal location for used batteries.
LB 253S
Briggs & Stratton
163
2900
2.6
BS OHV 992304
LB 348SI
Briggs & Stratton
163
2900
2.6
BS OHV 992304
135 - 004 - 21.11.2017