LENCO DAR-015 Mode D'emploi page 10

Dynamic Label Segment (DLS): Displays scrolling text information supplied by the broadcaster.
Signal Strength: Displays a signal bar with the current station strength.
Bit Error Rate (BER): Provides details of the signal error rate.
Channel Frequency: Displays the station's transmission channel number and frequency.
Program Type (PTY): Shows the type and description of the program provided by the DAB station.
Time&Date: Displays the time and date information provided by the broadcaster.
Bit Rate: The date rate of which the signal is being transmitted.
Station information on FM mode
Every time you press the Info/Menu button in the FM mode, the display will cycle through the
following display modes:
Program type: Displays description of the program provided by the radio station.
Signal Strength: Displays a signal bar with the current station strength.
Time and Date: Displays the time and date information provided by the broadcaster.
Frequency: Displays the station's transmission frequency.
Audio Type: Displays the audio type of the current station (Stereo or Mono).
Radio Text: Displays scrolling test information supplied by the broadcaster.
Note: To switch between mono and stereo by pressing the Enter button repeatedly.
Retuning your DAB+/FM Radio
You can retune your radio stations to store new stations or tune to a new region. Your preset stations
will remain stored when you perform a full scan retune. In DAB mode:
Press the Scan button to perform a full scan.
Progress will be indicated on the display.
When tuning is complete, the radio will play the first listed station or return to the last station played.
Using the Headphones
You can listen to your DAB/FM radio using headphones, just plug the 3.5mm jack into the back of your
device in the headphone jack. Control the volume by using the Volume knob.
Bluetooth
To choose your mode, press through your choices using the 'Mode' button. The choices will be
displayed on the front screen.
Turn on Bluetooth on your phone and 'Lenco DAR-015' will appear. Click on this to connect. When the
unit makes a short sound, it has successfully connected.
To choose music you will need to choose the album or playlist from your phone, but once selected you
can then use the Prev or Next button to select previous or next tracks.
10