DeWalt DW744 Guide D'utilisation page 7

FIG. 3
TABLE
SCREW-DOWN
HOLES
MITER
GAUGE
MOUNTING
HOLES
FIG. 4
BLADE GUARD
WORK SUPPORT
EXTENSION
(RETRACTED)
BLADE/WRENCH
STORAGE
RIP SCALE INDICATOR
BLADE HEIGHT
ADJUSTMENT
BEVEL LOCK
CIRCUIT BREAKER LEVER
BUTTON (DW744X ONLY)
ON-OFF SWITCH
ANTI-KICKBACK TEETH
RIP FENCE LATCH
DUST
EXHAUST
5
YOUR SAW SHOULD BE ASSEMBLED IN THE FOLLOW-
ING ORDER:
1. Blade
2. Rip fence (NOTE: Adjust rip scale before proceeding.
See Adjusting Rip Scale.)
3. Blade guard
4. Throat plate
Tools needed for assembly include a screwdriver and the
wrenches included with your saw
RAIL LOCK
ASSEMBLING THE RIP FENCE
LEVER
The rip fence can be installed on the left or right side of your
table saw.
FINE ADJUST
1. Locate the pin and opening on fence rails, as shown in
KNOB
Figure 5. Align the pin with the slot and align the latch with
the opening.
2. Secure the rip fence by snapping the latches onto the
rails as shown in Figure 6. Be sure to snap both latches in
WHEEL place.
ATTACHING/REPLACING THE BLADE
1. Raise the saw blade arbor to its maximum height by turn-
ing the blade height adjustment wheel clockwise.
2. Remove the arbor nut and flange from the saw arbor by
turning counterclockwise.
3. Place the saw blade on to the spindle making sure the
teeth of the blade point down at the front of the table.
Assemble the washers and arbor nut to the spindle and
tighten arbor nut as far as possible by hand, making sure
that the saw blade is against the inner washer and the
large washer diameters are against the blade. Ensure the
side of outer washer marked "Blade Side" is against the
blade (see Figure 7). Ensure the spindle and washers are
free from dust and debris.
4. To keep the spindle from rotating when tightening the
arbor nut, use the open-ended spindle wrench to secure
the spindle (see Figure 8).
5. Using the arbor wrench, tighten the arbor nut by turning
it clockwise (see Figure 8).
FIG. 5
PIN
OPENING