Switching On And Off - Bosch GBM 6 Instructions D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

GBM 6/RE - Buch Seite 2 Donnerstag, 7. November 2002 3:54 15

Always direct the cable to the rear away from

the machine.

When drilling use the auxiliary handle.

Hold tools by insulated gripping surfaces

when performing an operation where the

cutting tool may contact hidden wiring or

its own cord.

Contact with a "live" wire will make exposed

metal parts of the tool "live" and shock the op-

erator.

Do not drill, fasten or cut into blind areas

where electric, gas or water lines may exist.

Use appropriate detectors to determine if

these lines are hidden in the work area or

call the local utility company for assis-

tance.

Contacting electric lines may cause fire or

electric shock. Striking a gas line will probably

result in explosion. Breaking into a water pipe

will cause property damage or may cause an

electric shock.

If the drilling tool jams it will cause the tool to

jolt. If this occurs switch the tool off immedi-

ately.

When working with the machine, always hold it

firmly with both hands and provide for a secure

stance.

Be careful when screwing in long screws; dan-

ger of sliding off.

For screws, work using the first gear or with a

low speed.

Place the machine on the screw/nut only when

switched off.

Always switch off the machine and allow to

come to a stop before placing it down.

Never allow children to use the machine.

Bosch is only able to ensure perfect function-

ing of the machine if the original accessories

intended for it are used.

Inserting the Tool

Ring Gear Chuck (Figure A)

Insert tool and tighten equally in all 3 bores with

chuck key 7.

Keyless Chuck (Figure B)

Inserting the tool

Grip rear collar of keyless chuck 8 and rotate

front collar until chuck is open sufficiently for tool

to be inserted.

9 • 2 609 140 175 • 02.11

Clamping the tool

Grip rear collar and manually rotate front collar

until tight. An audible "click" indicates that the

chuck has automatically locked.

The locking mechanism is automatically released

when the front collar is rotated in the opposite di-

rection in order to remove the tool.

Screwdriver Tools

When using screwdriver bits 9, a bit holder 10

must be used. Use only the screwdriver bits that

fit the screw heads.

Belt Clip

The integrated belt clip makes possible the hang-

ing of the drill on a belt.

In this manner, both hands are free and the ma-

chine is always at hand.

Initial Operation

Always use the correct supply voltage: The

power supply voltage must match the information

quoted on the tool identification plate. Tools with

a rating of 230 V can also be connected to a

220 V supply.