Table des Matières
Publicité
WARNING
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do
so could result in electrical shock or personal injury from cleaner suddenly
starting.
Rear Belt
Cover
Couvercle de la
courroie
Cubierta de
la correa trasera
Lower Plate
Plaque inférieure
Base inferior
Electrical Shock or Personal Injury Hazard
Removing and Installing Lower Plate
Latches
Loquets
Lengüetas
Before servicing any parts, disconnect
vacuum from electrical outlet.
Place paper under nozzle whenever
lower plate is removed to protect floor.
Place handle in upright position and
turn vacuum over to expose lower plate.
Release lower plate by pressing two
(2) latches inward.
Remove lower plate and remove any
residue that may exist in belt area.
Close the rear belt cover and reinstall
lower plate by hooking front end of
lower plate into slots on front of
nozzle housing.
Make sure all wires are routed
properly and not pinched.
Press lower plate into place then
push two (2) latches outward.
- 26 -
Publicité
Table des Matières
