Using The Battery Charger - Waeco PerfectCharge MCP1204 Notice D'utilisation

PerfectCharge MCP1204/1207
Connecting the battery charger to the battery (fig. 4, page 4)
I
NOTE
The connection cable with the 12 V plug is only suitable for use
with Waeco cables and accessories.
➤ Insert the charging plug (1) into the 12 Vg socket (e.g. the cigarette
lighter), or...
➤ ...connect the connection cable (2) to the battery (3) using the battery
terminals, or to the battery charging points provided in the vehicle.
7.2

Using the battery charger

➤ Select the required mode:
Mode 1 (battery is connected): Press the button for 1 s.
Mode 2 (battery is connected): Press the button for 5 s.
Mode 3 (battery is not connected): Press the button for 10 s.
✓ The charging process starts in mode 1 and 2.
A constant voltage supply is started in mode 3.
✓ The LEDs show the charging progress of the battery of the battery
charger (see chapter "Status indications" on page 34).
➤ To end the charging process, press the button once again.
I
NOTE
When the red LED flashes because the battery voltage is under
9 V, you can charge the battery to over 9 V in mode 3. To do this,
disconnect the battery and switch to mode 3. Once the battery has
been charged over 9 V, you can switch the battery charger to
mode 1 or 2 again to start normal charging.
EN
Using the battery indicator
37