Using The Battery Indicator; Connecting The Battery Charger - Waeco PerfectCharge MCP1204 Notice D'utilisation

Using the battery indicator

8: Maintenance
In the maintenance phase, the charging voltage is switched off and the bat-
tery voltage is permanently measured. If it falls below 12.8 V, the battery
charger charges the battery up to a maximum of 14.4 V. Then it switches the
charging voltage off again and measures the battery voltage again.
This ensures secure winterizing, for example.
7 Using the battery indicator
A
NOTICE!
Make sure you do not reverse the polarity.
 Positive battery terminal: red terminal
 Negative battery terminal: black terminal
Incorrect polarity can damage the battery indicator.
7.1

Connecting the battery charger

➤ Check that the battery is in good condition:
➤ Check the following:
– The battery housing for damage
– The fluid level in the battery
Fill the battery with the medium specified by the manufacturer, if
necessary.
– The pole contacts
Clean off any dirt present.
➤ Connect the power cable for the battery charger to the 230 V AC mains.
➤ When you are using the connection cable with the 12 V plug: Switch the
vehicle ignition on.
36
PerfectCharge MCP1204/1207
EN