Use Of The Iu0U Automatic Charger - Waeco PerfectCharge IU1512 Notice D'emploi

_900_serie.book Seite 41 Mittwoch, 22. März 2006 4:28 16
IU0U automatic charger
➤ Insert the remote control into the opening created, so that the faceplate of
the remote control rests completely on it.
➤ Screw the remote control with two screws to the upper and bottom margin
of the faceplate – use the available drills.
230 volts voltage supply
➤ Connect the plug of the 230 volts voltage supply at the unit to an earthed
socket which is secured by an earth leakage circuit breaker.
6

Use of the IU0U automatic charger

For the safety notes when operating the unit see also
Chapter „Safety when operating the unit" on page 31.
With the IU0U automatic charger you can either recharge batteries or supply
empty batteries with a conservation charge.
➤ Switch the unit on with the power switch on the rear side of the unit.
6.1 Switching on and off with the remote control
(can be obtained from WAECO as accessory)
Note
The power switch at the unit (see Fig. 7-9, page 6) must be
switched on, so that the unit can be switched ON and OFF with the
remote control.
➤ Press the key "ON/OFF" on the remote control to switch ON or OFF.
Use of the IU0U automatic charger
41