Troubleshooting - Waeco PerfectCharge MCP1204 Notice D'utilisation

Troubleshooting

10 Troubleshooting
!
WARNING!
Do not open the device. You risk sustaining an electric shock by
doing this.
I
NOTE
If you have detailed questions about the battery charger data,
please contact the manufacturer (addresses on the back of the
instruction manual).
The red LED indicates a fault:
LED display Cause
Flashing Inverse polarity
Flashing Battery voltage < 9 V
Constantly lit Battery no longer
connected
Fuse in the connection
cable was tripped
40
PerfectCharge MCP1204/1207
Remedy
Check the cables and connections.
The battery cannot be charged.
Replace the battery.
The connection to the battery was
disconnected during the charging
process.
Check the cables and connections.
Replace the fuse (10 A plug-in fuse
for vehicles)
EN