Device Components; Fitting The Automatic Charger And Putting It Into Service - Waeco PerfectCharge IU812 Manuel D'utilisation

808-012.book Seite 19 Freitag, 12. Dezember 2008 7:54 19
PerfectCharge IU812
5.1

Device components

Item
in fig. 1, page 3
1
2
3
4
5
6 Fitting the automatic charger and
putting it into service
Caution!
a
The IU0U automatic charger must be installed in a place that is
protected from moisture and humidity.
Make sure:
– The installation location is well ventilated.
– The installation surface is flat and sufficiently firm.
The air intake on the underside and the air outlet on the back of the
IU0U automatic charger must be kept clear.
Warning!
e
Disconnect the mains plug before connecting or disconnecting the
DC voltage connection.
Warning!
e
Batteries with a cell short circuit may not be charged. There is a
danger of explosions due to the explosive gases.
Nickel-cadmium batteries and non-rechargeable batteries may not
be charged with the IU0U automatic charger. The sleeves of these
batteries can burst in an explosive manner.
Warning!
e
To connect the IU0U automatic charger only use cables not longer
than 2 m with a cross section of 1.5 mm² or more.

Fitting the automatic charger and putting it into service

Meaning
Fuse insert with glass fuse 10 A/250 V
"Power" indicator lamp
"Charging" indicator lamp
Connection terminal
Mains power cable (230 V)
19