Operating The Device Safely - Waeco PerfectCharge DC08 Notice De Montage Et D'utilisation

_DC Power Booster.book Seite 22 Mittwoch, 11. April 2007 8:31 08
General safety instructions
Electrical cables
If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Do not pull on the cables.
Fasten the cables securely.
Lay the cables so that they cannot be tripped over or damaged.
2.3

Operating the device safely

Caution!
Note the following basic safety information when using electrical
devices to protect against:
– Electric shock
– Fire hazards
– Injury
Make sure the polarity is correct.
Incorrect polarity can irreparably damage the device.
Operate the device only if you are certain that the housing and
the cables are undamaged.
Ensure that there is a sufficient cable cross section for the input
and output wires.
Make sure the air inlets and outlets of the device are not
covered.
Ensure good ventilation.
Even after the protective device triggers, parts of the device
remain live.
Always disconnect the power supply when working on the
device.
22
PerfectCharge / PerfectPower