GE IM-4B Manuel D'utilisation Et D'installation page 8

BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
refrigerator. To eliminate the danger of
electric shock during installation, you
must unplug the refrigerator from its
electrical outlet.
TOOLS YOU WILL NEED
Phillips screwdriver
1/4" Nutdriver or adjustable wrench
PREPARE FOR INSTALLATION
1
• Remove and discard the large white plug from the
rear freezer wall.
MOVE FEELER ARM TO THE STOP
2
POSITION
Move the feeler arm to the STOP (up) position. Leave the
feeler arm in the STOP position until the refrigerator is
connected to the water supply to prevent premature
operation.
(Appearance may vary)
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS
Unplug the
Pliers Sharp knife
Remove
plug
Feeler
Arm
3 INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted) into the
icemaker as shown.
PLUG IN THE ICEMAKER
4
Holding the icemaker in place, insert the icemaker power
cord plug into the socket, making sure that the prongs
and holes are matched. Press the plug firmly into the
socket. Lock the plug in place by clipping the restraints
onto each side of the plug. Make sure the restraints click
into place. Make sure the power cord is still in the hook on
the back of the icemaker.
Hook
1
Ice Maker
5 MOUNT THE ICE MAKER
Inside the freezer, loosen the 2 mounting screws but
do not screw them all the way out. If your model does
not have the screws already in the freezer wall, look for
two plug buttons. Remove the plug buttons and insert
the 2 philips head screws.The screws should extend
approximately 1/2" (13mm) out from the freezer wall.
Mounting Screws
8
Fill Cup
12
10