Unpack The Machine; Attach The Edge Guide; Attach The Guard; Assemble The Shaft - GreenWorks STF309 Manuel De L'utilisateur

8.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
8.2

ATTACH THE EDGE GUIDE

The edge guide can limit the cutting range of the machine
and decrease the risk of the damage caused by the rotating
cutting line.
1. Push the edge guide onto the trimmer head until it
engages in the slots.
2. The edge guide can be flipped up for storage.
NOTE
English
8.3

ATTACH THE GUARD

Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard (9) onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
8.4

ASSEMBLE THE SHAFT

1. Push the lower shaft into the upper shaft.
2. Align the groove on the lower shaft with the prominent
part in the upper shaft.
3. Slide the shafts until the release button (13) locks into the
positioning hole in the upper shaft.
4. Tighten the coupler (5).
7
WARNING
EN