Installing Batteries - Sony WALKMAN RDP-NWR100 Mode D'emploi

Installing batteries

If you use the R6 (size AA) batteries (not supplied),
install them in the unit by the procedure below.
1
Open the battery cover.
Open the battery cover, pushing the lower
part of it lightly.
2
Insert batteries (not supplied).
Insert three R6 (size AA) batteries,  end
first.
3
Close the battery cover.
Notes
Do not drop any foreign object into the unit when

replacing the batteries.
If you do not intend to use the unit for an extended

period of time, remove the batteries to avoid
possible damage from battery leakage and
corrosion.
BATT indicator status
Green: The unit is operating by the batteries
installed in the unit. When the battery
level falls, the indicator will become
dark.
Off: Any one of the following:
 The unit is turned off.
("WALKMAN" is in the standby
mode to play back.)
 The unit is operating by the power of
the "WALKMAN. "
 The batteries have run out.

Hints
When the batteries of the unit have run out, the

operation of the unit switches to the power of the
"WALKMAN" automatically.
The BATT indicator lights in green until

"WALKMAN" enters standby mode, even if you
stop playing back "WALKMAN. "
Note
While the unit is operating by the power of the

"WALKMAN, " the output level will be lower.
9
GB