Remote - Insignia NS-F27C Guide De L'utilisateur

Insignia NS-F27C 27" Flat Tube TV

Remote

1
INPUT
DISPLAY
MTS/SAP
1
4
7
RECALL
PICTURE
VOL
SCAN
No. Button
1 INPUT
2 DISPLAY
3 MTS/SAP
4 Number buttons
5 RECALL
6 PICTURE
7 MENU
8 VOL+/VOL–
9 SCAN
10 SLEEP
11
POWER
POWER
ZOOM
MUTE
2 3
5 6
8 9
0 CCD
AUDIO
CH +
VOL
MENU
+
CH -
EXIT
SLEEP
Description
Press to select TV, Video1,
Video2, S-Video, or
Component input.
Press to display channel
information.
Press to select Stereo, SAP,
or Mono audio.
Press to enter channel
numbers
Press to return to the
previous channel or source.
Press to select Personal,
Mild, Standard, or Vivid
picture mode.
Press to open the on-screen
display (OSD).
Press to increase o r
decrease the volume.
Press to scan through
memorized TV channels.
Press to set the sleep timer.
Press to turn your TV on and
off or to bring your TV out of
standby mode.
www.insignia-products.com
No. Button
12 ZOOM
13 MUTE
14 CCD
15 AUDIO
16 CH+/CH–
17 EXIT
Installing remote control batteries
Warning
Do not throw the batteries into fire. Dispose of
used batteries as hazardous waste.
Caution
Do not drop or disassemble the remote control. Do
not get the remote control wet.
Important
If you insert the batteries incorrectly, you will not
damage the remote control, but the remote control
will not work.
To install batteries in the remote control:
1 Remove the battery cover.
2 Insert two AA batteries into the battery
compartment. Make sure that the + and –
symbols on the batteries match the + and –
marks inside the battery compartment.
3 Replace the battery cover.
Note
When the remote control will not be used for a
long period of time or when the batteries are worn
out, remove the batteries to prevent leakage.
Description
Press to select Normal, 16:9,
or Enlardge zoom mode.
Press to mute the sound.
Press again to restore the
sound.
Press to turn close captions
on or off.
Press to select an audio
mode.
Press to change to a channel
with a higher or lower
number.
Press to turn off the channel
display and to exit system
menus.
5