Back; Remote; Setting Up Your Tv; Installing Remote Control Batteries - Insignia NS-R20C Guide De L'utilisateur

Insignia NS-R20C Round Tube TV

Back

No. Jack Description
1 Antenna Plug an outside antenna into
this jack.
2 S-VIDEO Plug an S-Video cable into
this jack and into the jack on
an S-Video device.
3 AUDIO IN R/L Plug the left and right audio
cables into these jacks and
into the left and right AUDIO
OUT jacks on an external
device.

Remote

No. Button Description
1 MUTE Press to mute the sound.
Press again to restore the
sound.
No. Button
2 Number buttons
3 DISPLAY
4 AUDIO
5 CCD
6
CH
VOL
7 MENU
8 POWER
9 RECALL
10 PICTURE
11 INPUT

Setting up your TV

Installing remote control batteries

To install remote control batteries:
1 Remove the battery cover.
2 Insert two AAA batteries into the battery
compartment. Make sure that the + and –
symbols on the battery match the + and –
symbols inside the battery compartment.
3 Replace the battery cover.
www.insignia-products.com
Description
Press to change the channel.
To enter a two-digit channel
number, press the two
buttons within 1.5 seconds
of each other. For example,
to select channel 12, press 1
then press 2. The channel
changes in about 1.5
seconds. If you press 0
before you press 1, the
channel changes
immediately.
Press to display channel
information.
Press to select the sound
mode. Your can select
STANDARD, NEWS, MUSIC,
or MEMORY. You can set up
your own sound mode
settings and save them
under the MEMORY mode.
Press to turn closed
captioning on or off.
Press the channel buttons to
, CH ,
change channels.
, VOL
Press the volume buttons to
increase or decrease the
volume.
Press to open the on-screen
display (OSD).
Press to turn your TV on or
off. If your TV is in standby
(power saving) mode, press
to exit standby mode.
Press to go to the previous
channel you were watching.
Press to select the picture
mode. You can select
STANDARD, DYNAMIC,
MILD, or MEMORY. You can
set up your own audio mode
settings and save them
under the MEMORY mode.
Press to select the video
input source.
3