Publicité
4.2. Assembling and disassembling the combs
The machine is shipped with the combs removed. For assembly, align the markings on
rotor and comb and follow the images below.
4.3. Cleaning and lubrificating the machine
The machine should be cleaned at the end of season so as to prevent solid particles
and dust affecting the efficiency of the mechanical parts.
4.4. Storage
If you do not expect to use the machine for some time proceed as follows:
-
disconnect the machine from the power supply;
-
clean the machine: remove any dirt from its surfaces or any dirt in the midst of
mechanical parts;
-
check and, where necessary, replace any damaged/worn parts;
-
cover the machine to stop dust settling on it.
Carrying out the above maintenance tasks will ensure that the machine is in perfect
working order when work is recommenced.
4.5. Dismantling the machine
Disconnect the machine from the electrical power supply and cut the power lead.
The machine is made of materials that can be re-used or recycled, the most important of
which is iron. Hand your machine over to an official materials recycling centre.
Help safeguard the environment by applying proper waste disposal practices to the
packaging of the machine too.
Your local authority will be able to provide you with information on best waste disposal
practices so as to ensure observation of environmental protection standards
TORNADO CARBON V3 - TP V3
Castellari S.r.l.
•
Via Lasie 16/E
•
IMOLA (BO)
29
29
Publicité
Chapitres
