Publicité
the health and safety of that person). This rule is particularly important for persons
not trained to use the machine.
-
The area around the machine work zone must always be kept clean and free from
any obstructions. Make sure no persons or animals are in the area of machine
operation.
-
When a person is "exposed", that is, in a "danger zone", the operator must
immediately stop the machine and ensure that person leaves the danger zone.
-
When the machine is running, the worker must maintain a position that will allow
complete control of the machine so that appropriate action can be taken according
to circumstance.
-
Before leaving the machine unattended make sure the power supply is detached.
-
Periodically check the machine is in good working order, safety devices included.
2.3.2. Safety: maintenance
-
Before carrying out any work on the machine, make sure the power supply is
disconnected.
-
Maintenance tasks must always be carried out by personnel qualified for such
tasks.
-
At the end of maintenance/repair work the technician must make sure that the work
has been completed, the safety devices re-enabled and the covers re-fitted before
restarting the machine.
-
Use of appropriate personal protection equipment during maintenance/repair work
is compulsory. Such equipment includes:
Gloves
Adjustment work done with safety devices disabled or covers removed must be carried
out by one worker only; when such work is being carried out access to the machine by
unauthorised personnel is prohibited. Prevent dust deposits on the machine, especially
on electric motor and intake filters.
NOTE: Do not direct water jets against the machine (e.g. to clean it); this could
cause short-circuiting!
2.4. Ecology and pollution
2.4.1. Waste management
Use and maintenance of the machine generate waste products that must be disposed
of in compliance with the laws in force in the country where the machine is used.
The user must comply with the instructions regarding routine use, cleaning
and maintenance of the machine provided by the manufacturer.
Any special waste must be disposed of by specialised firms authorised to do so.
Ensure waste is disposed of properly by requesting a "waste disposed of securely"
receipt. For information on how to dismantle the machine see section 4.5.
26
TORNADO CARBON V3 - TP V3
Hard hat
Castellari S.r.l.
•
Via Lasie 16/E
Ear protection
•
IMOLA (BO)
Anti-slip footwear
with steel toecaps
Publicité
Chapitres
