Operating Elements; Intended Use - Olympia PS 612.2CCD Mode D'emploi

Switch „ON / OFF" turns the unit on (position ON or I). The unit is ready for use.
The unit has a microswitch - cutting starts when paper is inserted.
Press switch FWD (forward). The cutting unit runs (always).
Paper can be inserted for cutting.
Push switch REV (reverse) to push back the paper.
Release Switch REV to shred the paper remaining in the cutting unit.
Lamp „power": The equipment is switched on and ready for use.
Lamp „Working": The cutting unit runs
Lamp „REV": The unit recognizes overload (too many sheets of paper) and sets
automatically to Reverse-mode
Lamp „Basket full": The container is full and must be emptied.
Lamp „Box open": The unit was opened, in order to empty the container.
Close the unit.
The shredder may only be used to shred paper, CDs or credit cards in the infeed slots
provided. The material to be shredded must be dry and must correspond to the specifi-
cations listed in the technical data. Shredding other materials can lead to injuries (for
example, if solid material splinters) or damage to the device (destruction of the cutting
unit, etc.).
Do not shred endless paper documents with this device. Remove all paper clips and
staples before feeding paper into the device.
The device may only be used indoors in dry rooms.
- Take the device carefully out of the packaging.
- Plug the mains cable into the socket. Please observe the energy supply specifications
on the back of the device in your safety measures.
- The socket and the mains connection of the device must be freely accessible for
safety reasons so that the power supply can be disconnected in emergencies.
8

Operating elements

Intended use

Starting up