Télécharger Imprimer la page

Beta 1498 TB/W Mode D'emploi page 12

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
disconnect any devices, including the radio, the courtesy lights and the air conditioner; confirm with
the <I> key. If, at the third confirmation attempt, the trouble at the battery poles has not been dealt
with, the following message will be displayed:
D
I
The message:
means that at least one cell of the battery is not working. Replace the battery; recharging it is
dangerous. The message:
R
E
recharge the battery and test it again; if the result is the same, replace the battery.
The message:
G
O
means that the starting power is > 70%, although voltage is low; it will be enough to recharge it.
TRANSMISSION OF DATA TO PRINTER Beta 1498 ST/W (Optional)
Press the <
> key to send the data to the printer wirelessly
Reference Standards
The study instrument complies with EMC Directive 89/336/EEC of 03/05/89, designed to harmonize
standards concerning electromagnetic compatibility in EEC member states, and the following
directives, 92/31/EEC of 28/04/92 and 93/68/EEC of 22/07/93 (amending previous Directive
89/336/EEC). Reference should also be made to Directive 76/89/EEC, concerning immunity, and
Italian Legislative Decree n°. 476 of 04/12/92, concerning implementation of the standard.
WARNINGS:
DURING ONBOARD CONNECTION,
DO NOT TOUCH THE CAR BODY WITH THE RED CLAMP; IT IS RECOMMENDED TO CONNECT
FIRST THE RED CLAMP TO THE POSITIVE POLE, THEN THE BLACK CLAMP TO THE NEGATIVE
POLE
DANGER OF SHORT-CIRCUITING!!
TEST FAILS WHEN:
TESTER DOES NOT TURN ON BECAUSE IT HAS BEEN WRONGLY CONNECTED TO
TERMINALS
– SWITCH CLAMPS
TESTER DOES NOT TURN ON BECAUSE TEST BATTERY IS LESS THAN 8.0 VOLTS
– REPLACE BATTERY
BATTERY HAS JUST BEEN CHARGED (MESSAGE: AMP 0)
– WAIT AT LEAST 1 HOUR BEFORE PERFORMING TEST OR DISCHARGE BATTERY
(CONNECTING A CHARGE) FOR A FEW SECONDS (DEPENDING ON CHARGE); THEN WAIT
A FEW MINUTES AND PERFORM TEST.
COURTESY LIGHTS OR ACCESSORIES ARE ON IN VEHICLE (MESSAGE: DISCONNECT
DEVICES)
– TURN EVERYTHING OFF AND REPEAT TEST
EITHER CLAMP IS NOT PROPERLY CONNECTED TO TERMINAL (MESSAGE: CHECK
CONNECTION)
– MOVE CLAMPS UNTIL MESSAGE DISAPPEARS
S
C
O
N
N
T
R
Y
D
A
M
A
G
C
H
A
R
G
O
D
+
E
C
T
B
A
G
A
I
N
E
D
C
E
E
+
R
E
T
R
E
C
H
A
A
T
T
.
L
L
E
S
T
R
G
E

Publicité

loading