What If There Are Problems - Beurer JBY 96 Mode D'emploi

13 What if there are problems?

Faults
Power LED does not
light up after switch-
on.
An acoustic signal
sounds from the
parent unit.
The signal is weak,
the connection keeps
breaking up or there is
interference.
No acoustic signal
sounds from the
parent unit.
A device switches
itself off .
Actions
Check whether
• the relevant adapter plug is properly plugged in,
• the batteries are full or the rechargeable battery
needs charging or is damaged.
Check whether
• the maximum range has been exceeded
• the power supply unit for the baby unit is cor-
rectly connected
• the baby unit is switched on
• the batteries are full or the rechargeable battery
needs charging or is damaged.
• If another technical device such as a micro-
wave is in the area between the parent and
baby units, remove the device or switch it off .
• Check whether other factors, such as trees etc.
are in the path of the two devices, and change
the position of the devices until the parent unit
signals a connection.
• Check whether the baby and parent units are
inside the respective receiving range.
• Adjust the volume on the parent unit.
• Change the batteries or recharge the battery.
35