In The Event Of Problems - Beurer Janosch JBY 86 Mode D'emploi

perature, electromagnetic fields and nearby
sources of heat (ovens, heaters).
• If dirty, wipe the device with a soft, dry
cloth.
• Clean the devices with a dry cloth.
• Do not use any abrasive cleaning prod-
ucts.

11. In the event of problems

Faults Action
Displays do Check whether
not illumi- • the relevant adapter plug is
nate after properly plugged in,
switching • the batteries are charged/not
on. too weak,
• the batteries have been cor-
rectly inserted.
No acoustic Check that
signal is • the transmitter is switched on,
transmitted • the same pilot tone setting
by the recei- was selected on the trans-
ver. mitter,
• the same channel was
selected on the transmitter,
• fully charged rechargeable
batteries/disposable batte-
ries that are not too weak are
inserted in the transmitter,
• the maximum range has not
been exceeded.
All manuals and user guides at all-guides.com
12. Disposal
Batteries do not belong in household waste.
As a consumer, you are required by law to
recycle used batteries. You can recycle your
old batteries at public collection points in
your community or wherever the same bat-
teries are sold.
Note: Batteries containing
pollutant substances are
marked as follows:
Pb = Battery contains lead,
Cd = Battery contains cad-
mium, Hg = Battery con-
tains mercury.
19
Faults Action
You can As this baby monitor uses analo-
hear other gue radio technology, other radio
radio com- communications can cause inter-
munica- ference. If this happens, switch
tions. to another channel or change the
pilot tone setting.
Connection Check whether another techni-
is always cal device such as a microwave
breaking up is positioned between the recei-
and there is ver and the transmitter. Reposi-
interference. tion the devices if necessary.
Devices will Change the batteries or connect
not switch the devices to the mains adap-
on. ter plug.