Beurer JBY 96 Mode D'emploi page 28

If the parent unit battery is low the unit will beep twice and the LED will fl ash
red. If the device is not connected to a socket, it will switch off automatically
after a short period.
If the devices are operated using the power supply unit and there is a power
cut, the parent unit switches to battery operation. For this reason, the
standby time is dependent on the battery charge status.
Discharging the parent unit
The battery should be discharged after being charged 300 times. To
do so, leave the unit switched on until it switches itself off automati-
cally.
1. Position the baby unit so that it is in an elevated position and is not in
proximity to any other devices that may cause interference. Switch on
the baby unit with the
up red.
2. Set up the parent unit in the room where you are going to be, or clip it to
your belt using the belt clip.
3. Switch on the parent unit with the
parent unit lights up green when the baby and parent units are ready to
receive.
If there is no connection between the devices (baby unit not
switched on or out of range), an acoustic warning will sound on the
parent unit and the power LED will light up red.
Transmission mode
Both power LEDs permanently light up green.
Eco + mode
The power LEDs fl ash green every 6 seconds (see 4. Notes).
Press the /SET button on the parent unit to change to Eco
28
button. The power LED of the baby unit lights
button. The power LED of the
+
mode.