DoorBird D20 Série Manuel D'installation page 5

MODEL ATTACHMENT METHOD
D201 With screws
D202 With screws and / or grout
With screws and / or grout. Additional holes and mounting
D203
housing may be required
With screws and / or grout. Additional holes and mounting
D204
housing may be required
D205 Depends on the environment / integration
STEP 7: PREPARING THE WIRES
Remove about 5 mm of insulation material at the end of the wires that you
would like to connect to the Video Door Station.
STEP 8: CONNECTING THE WIRES
It is possible to connect the Video Door Station conveniently and safely via
the colour-coded cable harness on the reverse of the Video Door Station.
Please use appropriate crimp connectors or terminal strips to connect the
supplied cables with your wires. The accompanying crimp connectors are
weatherproof and are equipped with heat-shrink tubing which can be sealed
after assembly by, for example, carefully using a heat gun.
T+ T- R+ R- O1 O2 C1 C2 B1 B2 V- V+
8
CONNECTOR DESCRIPTION
White and orange network cable wire
T+
(Number 1, Transmit Data +)
Orange network cable wire
T-
(Number 2, Transmit Data -)
White and green network cable wire
R+
(Number 3, Receive Data +)
Green network cable wire
R-
(Number 6, Receive Data -)
Electric door opener
O1
(zero potential)
Electric door opener
O2
(zero potential)
C1 Electric door chime (zero potential)
C2 Electric door chime (zero potential)
B1 Door-opening button
B2 Door-opening button
V- Power supply, negative pole (-)
V+ Power supply, positive pole (+)
Please take care when connecting the wires. Connecting the wires the wrong
way may destroy the Video Door Station.
STEP 9: ANTENNAS
Screw the external 2.4 GHz WiFi antenna using an Antenna extension cable
to the designated position on the back of the Video Door Station. Screw also
the external 433 MHz RFID antenna using an Antenna extension cable to
the designated position on the back of the Video Door Station. We recommend
to feed the antennas out of the housing for better reception and transmission
power, because it is made of metal (shields). If you don't want to use WiFi
or RFID at all, you don't have to screw the respective antenna to the designa-
ted position.
STEP 10: FINAL ASSEMBLY
Applies only to DoorBird Video Door Station D201 and D202: Screw the front
panel with the attached Video Door Station to the mounting housing with
WIRE
white-orange
orange
white-green
green
purple
purple
blue
blue
yellow
yellow
black
red
10